Logo

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

Last Updated: 21.06.2025 01:37

What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?

This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.

2024–10–00 [ Ammar Mahdi ] Ammar Mahdi

He then asserts :

Is it possible for humans to determine their past life as an animal? Is there a scientific method to prove this?

He then describes Rainy Season and Lightning.

Can the fuse protect the electronic devices from lightning instead of a surge protector.

The bolt then partially travels down the line to your home.

What is your favorite cuckold experience?

But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).

This is where the MOV conducts again, and dissipated the energy.

but I think this circuit , shows a few more pieces.

What is the difference between the terms "Millennials" and "kids"?

2024–10–14 [Omar Gharbi Omar Gharbi ]

One

This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.

All New GTA Online Vehicles In Money Fronts Update And Prices Revealed - RockstarINTEL

P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.

Upvotes:

[image of Common-mode choke]

Why don't we hear our own snoring?

eight

It seems Mohan does not understand the difference between a comment and an Answer.

Because the load is inductive, the current lags the voltage.(by a bit).

What made you recently say to yourself, “Wait. Really?”

nine

what exactly is a ‘surge’ protector?

Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.

Who was the guy that had sex with the AIDS monkey?

The other is “what does a “fuse” do?”

This is the picture of an electronic coil of wire wound around a core of magnetic material.

Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.

What the early "F1" movie reviews are saying ahead of New York premiere - Motorsport.com

the problem then depends on "how fast does the fuse operate?".

When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.

For this case there are devices called Metal oxide varistors (MOV).

Who is the beast of Revelation 13?

so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.

Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.

(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).

If gays can get married, why can't I marry my dog or a cheeseburger?

There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.

Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.

It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.

Analysts revamp forecast for Nvidia-backed AI stock - TheStreet

So, the voltage could go up to 500 volts, and the fuse will not open up.

There are three different concepts here that are getting confused.

2024–10–16 [ OO OLAOYE OYEBODE ]

Biotech pauses trial after second patient death linked to gene therapy - The Washington Post

The third is lightning and “how it gets conducted into a home.”

A fuse is a non-resetable over current circuit protector.

Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.

Have you ever had sex with sisters?

so, what happens?

“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”

At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.

Can you share a story of someone who had a lucky experience while hitchhiking?

but this device (an Inductor) … impedes the rapid changes in the current.

At one ohm, the resistor has a maximum of 1 watt power.

This device then solves the entire problem.

HBO’s Gruesome True-Crime Doc Tried to Have Its Bombshell Moment. There’s Just One Problem. - Slate Magazine

These devices are installed between the “hot” and “neutral” and protective ground.

What is lightning?

Now when you have a certain ac resistance, then a current flows in a loop.

2024–10–10[John johnson John Johnson ]

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”

This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.

In schematic diagrams this is the symbol for a fuse:

First Sentence:

Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".

2024–10–11 [Bobby Sanchez Bobby Sanchez ].

2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?

At least they know the answer if they wanted it.

2024–10–11 [Victor Olarewsju Victor Olarewaju ]

The MOV will conduct when the voltage exceeds 50% of line voltage.

It also is a device that limits the change in current flow.

Here is a simplified AC power diagram.

What does a fuse do?

a photo is worth a thousand words.

These are simplified answers to the original question, and does not change anything I wrote above.

One is “what exactly is in a ‘surge protector’ ? ”

So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.

“ A fuse is a device which protects the (circuit) against overload and short circuit.”

OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.

Barnstars:

An AC voltage/ current source, and an ac inductive load.

But… the neutral is now “floating” because of the 1 ohm resistance.

I post the exact comment here.

And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.

But it can get overloaded, and no longer works.

A circuit breaker is similar, but is resettable.

This is 'the assistant's answer'

So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.

If the nominal power is 4,000 watts then the current at 230volts is 16 amps.

(Dc diagram shown, AC is similar).

This one hit behind the barn.

He then describes the function of a fuse.

[old diagram got deleted by accident]

This is where this question deviates from being a 'generic' question, and becomes more specific.

Edit 2024–10.

There are two important concepts here.